Replacement Requirements:
Shaft Size: Fits most HORIZONTAL SHAFT engines with a 3/4" Diameter Shaft. The shaft should be approximately 2 inches long.
Motor: Fits Engines Below 7 Horsepower
Bolt Pattern: 4 Bolt Pattern where each hole is approximately 2 1/2" apart
It Will NOT Work for:
Shaft Size:
- DOES NOT FIT 1" HORIZONTAL SHAFT. See our listing for an AR RRV4G40
-DOES NOT FIT shaft shorter than 2 inches long or 7/8" HORIZONTAL SHAFT
**If you have an Excell Pressure Washer with Plastic Shroud please be sure to check your crankshaft before ordering
Motor Size: DOES NOT FIT ABOVE 7 Horsepower motors. If your motor is more than 7 Horsepower see our listing for AR RRV4G40
If you need a 1" Shaft, check out our listing for an AR RRV4G40-400

• This is a great replacement pump for your worn out pump. This unit IS designed for daily use and it is perfect for contractors.
• This pump is capable of producing up to 3000PSI at 2.5 GPM. I personally own a unit with this pump on it and have used it for almost 4 years with NO problems. This is a top quality replacement that will rival any pump on the market.
• The pump includes a built in unloader, a thermal relief valve, and a chemical injector.
• This pump is completly rebuildable from the valves to the packings and unloader. It is already pre-filled with oil.

This is a great replacement pump for your worn out pump. This unit IS designed for daily use and it is perfect for contractors.Creation dream