Installation:

If your monitor is using a inverter, then this kit replace the inveter to plug into the driver board ;
If your monitor is a high-voltage integrated power supply board, then: the board energized, find 12V (capacitance), and then unplug the power supply,use a multimeter to find and 12V (capacitance) . Disconnect original connecting the negative terminal, the board received three cables: 12V, ON, GND, the 12v of the inverter connect with 12v positive electrode of high-voltage intergrated power supply board,GND is connected with the negative electrode, ON connect with the ON / OFF. In simple terms, the original high voltage power supply is disconnected,instead of the inverter.

VIN : voltage
ENA: on/off
DIM: ADJ adjust brightness
GND: Connecting Ground

Package:

2x LED backlight strip
1x LED Driver board
1x cable

• This is a 540mm dimmable LED backlight strip kit,Update LCD monitor to LED
• LED backlight strip: L/W/H:540mm*4mm*3mm.Can be cut by every 3 lamps as a group.
• Support 15'' to 24'':15'',17'',19'',19''wide,20'',21'',22''wide,23'' 24''.
• LED board: L/W:7cm*2cm ,9-30V input.

This is a 540mm dimmable LED backlight strip kit,Update LCD monitor to LEDTH