30 Days Lowest Price Guarantee
Elite Screens Inc. Airflex5D Double Lumens Dual-Projector Stacking Processor with Stacking/Scaling/Warping and Built-in QStack Grid System AF5D-20
$ 399.00
DESCRIPTION
Frequency Asked Questions
Q: Why would I need to "stack" projectors?
A: Stacking is an excellent way to achieve the same high levels of brightness and color performance created exclusively by expensive commercial grade projectors at a fraction of the cost. The Airflex stacking processors will provide entry-level to higher-end projectors with the ability to combine their output in a perfectly aligned, bright and clear image that rivals top-tier products. In addition to this, other features like geometric correction and even passive 3D presentations are also possible to be presented with the same setup.
Q: Is the Airflex5D system calibration/alignment automatic?
A: No, the Airflex unit must be manually aligned using keypads on the front panel or Remote Controller without PC system during its initial installation. From that point onward, its internal software will maintain the alignment.
Q: What is the measured luminance foot-lambert per square meter of all four projectors?
A: The measured luminance (cd/m2) of four stacked projectors used to achieve 4x the brightness will vary depending on the output of lumens from each projector. Airflex performance testing involved the use of a luminance meter to measure the image brightness of four projectors with identical output and the results were images with four times the brightness.
Q: How long does it take to align and calibrate a system?
A: The initial setup may take a beginner from 10 minutes to an hour. This is significantly less than costlier stacking products that may require several hours of a professional's time to calibrate. From that point onward, its internal software will maintain the alignment.
Q: Is Airflex5D system a one-time set up? A: Yes, once it is calibrated, the internal software will maintain the alignment.
Q: Why would I need to "stack" projectors?
A: Stacking is an excellent way to achieve the same high levels of brightness and color performance created exclusively by expensive commercial grade projectors at a fraction of the cost. The Airflex stacking processors will provide entry-level to higher-end projectors with the ability to combine their output in a perfectly aligned, bright and clear image that rivals top-tier products. In addition to this, other features like geometric correction and even passive 3D presentations are also possible to be presented with the same setup.
Q: Is the Airflex5D system calibration/alignment automatic?
A: No, the Airflex unit must be manually aligned using keypads on the front panel or Remote Controller without PC system during its initial installation. From that point onward, its internal software will maintain the alignment.
Q: What is the measured luminance foot-lambert per square meter of all four projectors?
A: The measured luminance (cd/m2) of four stacked projectors used to achieve 4x the brightness will vary depending on the output of lumens from each projector. Airflex performance testing involved the use of a luminance meter to measure the image brightness of four projectors with identical output and the results were images with four times the brightness.
Q: How long does it take to align and calibrate a system?
A: The initial setup may take a beginner from 10 minutes to an hour. This is significantly less than costlier stacking products that may require several hours of a professional's time to calibrate. From that point onward, its internal software will maintain the alignment.
Q: Is Airflex5D system a one-time set up? A: Yes, once it is calibrated, the internal software will maintain the alignment.
- Stacked configuration greatly enhances picture brightness
- Doubles the brightness when used in 2D stacked dual projector configurations
- Maximum output of 1920 x 1080
- Easy setup & alignment through full-function remote or front panel interface
