GDW - Steel Golf Shaft Extensions for Irons - available in .620 - .600 - .580 (New Lighter Model) With most standard steel shaft extensions a 1" inch regular extension will increase the swing weight from 6 to 7 SW points. The Golf Design Works Extensions - 1"inch will increase the swing weight by only 3 points. Our shaft extensions are meant to be cut in half to allow you 3 inches of possible extension for each half. You may also use one extension for a total possible extension length of 6 inches for one shaft. Our extensions allow for more insertion into the shaft which give more of a counter balance the swing weight and better adhesion of the epoxy. Other shaft extenders on the market have a very short insertion point which does not allow for a good adhesion and counter balance. The Golf Design Works Steel Golf Extensions have a nice shine finish and now lighter than our previous model. One extension will allow you to cut it in half therefore allowing you to extend two shafts. We have a 100% guarantee your satisfaction.

• Durable Light Design
• Dual Reducer Ends - One extends two iron Clubs
• 3 Extensions Included to Extend 6 Clubs
• New and Improved 3" insertion point for better adhesion and counter balance
• Very easy to Install

Durable Light DesignGDW