Pearl Jacky M53-G Pearl Sump Pump with Float Switch JACKY pump can be used to pump clear or dirty water from small tanks, drains, and waste water systems. It is equipped with a vertical switch, a 25-feet (7.5 m) power cable, and it allows the passage of solids in suspension up to ½ (13 mm). This pump does not require any additional accessory to maintain the correct water level in the tank where it is installed. WATER PUMP: Vertical float switch or manual Discharge diameter 1 1/2 NPT Cast iron pump casing Vertical level switch allows installation on small-sized tanks (12ft 3.66 m) Vortex impeller Stainless steel shaft Maximum liquid temperature: 104F (40C) for continuous duty operation / 140F (60C) for intermittent duty operation Minimum submergence depth: fully submerged for continuous duty operation / (15 cm) below the top of the motor for intermittent duty operation Mechanical seal MOTOR: 1/3 hp, monophasic, 115 Volt, 60 Hz, 3450 rpm Rated current 10 A Copper induction motor Cast iron pump body IP65 protection Techno polymer base Stainless steel hardware Built-in thermal protection

• Pearl Jacky M53-G Pearl Sump Pump Without Float Switch
• Power:0.3 hp, Phase:1
• Volts:115v, Max. Amp:9A
• Stainless steel shaft
• Two Year Manufacturer Warranty

Pearl Jacky M53-G Pearl Sump Pump Without Float SwitchPearl