Electric Hydraulic Pump Double Acting Manual Valve Power Pack 10000 PSI

Introduction :

The electric oil pump system is composed of three-phase asynchronous motor, high-pressure oil pump and fuel tank. It has the advantages of small volume, small pressure, light weight, simple structure and convenient use. The pump in order to always be able to observe the work of the pressure changes, special equipment gauge pressure gauge standby interface for the user to install the pressure gauge purposes.

Tech Date:

Model Number:DYB-63B-2

Power: Hydraulic

Pressure:High Pressure

Function: Double-acting, manual valve

Standard or Nonstandard:Standard

Frequency:60Hz

Power:750W

Voltage:110V

Oil storage volume of:8L(488in³)

Rotate speed:1400r/min

Electric current:3.5A

Flow-Hypertension:0.7L/ min(43in³/min);Low-5L/min(305 in³/min)

Rated working pressure -63Mpa,High pressure:70Mpa(10000PSI),Low pressure:2Mpa(300PSI)

The role of maintenance Note:

1, the oil pump with 20 oil.

2, the oil storage capacity must be within the scope of the oil window.

3, each refueling and oil, you must use more than 80 mesh filter oil filter, the need to clean the replacement tank. The oil change period is six months.

4, working oil temperature of 10 degrees Celsius to 50 degrees Celsius.

5, start the electric pump before the need to open the venting nut, open the switch placed in unloading position.

6, the use of the motor temperature is too high, should stop using. Self-cooling and then use.

8, high-pressure tubing factory into, after 105MPA test. But because the hose is easy to aging, so the user should always check, usually six months, frequent use for three months, 87.5MPA pressure test, if damaged, raised, leakage phenomenon, can not be used.

• Model Number:DYB-63B-2;Power: Hydraulic;Function: Double-acting, manual valve
• Power:750W;Oil storage volume of:8L(488in³);Rotate speed:1400r/min
• This two-speed pump requires fewer cycles to move a load than a similarly rated single-speed pump, increasing 70% productivity.
• The pump factory has been adjusted well, not free high-profile, need to be re-adjusted, must be carried out with the pressure gauge.
• This two-speed hydraulic electric pump is for lifting, bolting, or applying pressure with a hydraulic cylinder (sold separately) at faster speeds and for longer periods of time than a hand pump in construction, manufacturing, and maintenance and repair applications.