Weighs 34 lbs . ROHN does not recommended telescoping masts for commercial, CB or beam antenna installations. The antenna top load should not exceed an effective projected area of 2 sq. ft. Pictured guy layouts are for a typical installation - individual installation requirements may vary. Erecting the Telescoping Mast is made by simply connecting guys and brackets to the attached unique heavy duty rolled edge guy rings and clamps, extend the sections, insert the locking cotter pins, rotating the tubes to a locked position, and tightening the clamps. The unique ROHN Telescoping Mast design features interior tube flanging combined with a double crimped exterior tube to produce a stronger and more stable joint than most common masts. This exclusive design also prevents the sections from accidentally pulling apart and allows disassembly by pulling each section out through the lower end. Each section extends deeper in to the lower tubes than most other Telescoping Mast designs, adding still further to the stability of the structure. Due to overlapping extended masts will be shorter. ** Shipped with signature required **

• Rohn 9H50 Mast with Easy Up EZ 32A Heavy Duty Ground Mount Bundle
• Mast Specs- Bottom: 2-1/4"/ OD Top: 1-1/4" OD / Shipping Length: 99" / 410" (34') Actual Extended Pipe Length - Assembled Height will be around 30'
• All sections are 18 gauge except for top which is 16 gauge
• Pre-galvanized for corrosion protection. Comes assembled with hardware. Top rings are adjustable based on antenna mounting
• Plate is 11 Gauge Steel x 9" x 9" with Pin for concrete embedment. Mast held in place with heavy duty set screw. ((Any and all guy wires, guy anchors, lightning protection, etc not included)). Ships as 2 separate packages.

Rohn 9H50 Mast with Easy Up EZ 32A Heavy Duty Ground Mount BundleROHN