Saniflo SANISHOWER Gray Water Bathroom Pump 010 Sink
Saniflo SANISHOWER Gray Water Bathroom Pump 010 Sink
30 Days Lowest Price Guarantee

Saniflo SANISHOWER Gray Water Bathroom Pump 010 Sink

$ 447.55

DESCRIPTION

Dimensions (Height x Width x Depth) 5¾'' x 11-5/8'' x 6-3/8'' Discharge Pipe Diameter (in) 3/4'' Discharge Rate at Max. Height (gpm) 14 Electrical Supply (V) 115 Horizontal Discharge (ft) 100 Horsepower 0.2 Maximum Temperature (°F) 104 Min. Gravity Fall on Horizontal Run 1/4'' per foot Motor Speed (RPM) 3600 Vertical Discharge (ft) 12
  • The Sanishower is a small drain pump that may be used to pump waste water away from a shower, sink, bar sink, or other fixture. The Sanishower is small enough to fit underneath a raised shower base. Alternatively, it can be placed behind a wall or beside a shower. The Sanishower will pump wastewater up to 12 feet in height and/or 100 feet away from a soil stack
  • As a point of interest; quite a few pedicure manufacturers are putting the Sanishower inside pedicure chairs. Due to its quiet operation and ease of installation, they have become the choice of OEM's. The inside of the Sanishower is comprised of a pressure chamber, which starts and stops the unit, and the motor, which drives the pump.
  • When the water enters the Sanishower, it activates a micro switch in the pressure chamber, which in turn starts the motor. The motor is sealed for life in an oil filled enclosure. A spindle/shaft drives the impeller and therefore the moving parts are kept to an absolute minimum. Water enters the chamber and is pumped away into the sanitary sewer.
  • The unit pumps the effluent upward to 12 feet and/or 100 feet horizontally (with gravity fall). Once the water is discharged and the water level in the container goes down, the micro switch deactivates the unit until water enters the unit again. A normal operating cycle for the Sanishower can be as short as 2 - 10 seconds depending upon the discharge pipe run configuration; power consumption is therefore minimal.
  • In addition to sinks, the Sanishower will also accept and discharge the waste water from a variety of other sanitary fixtures such as: a shower, a urinal, etc. When adding a shower, a base will have to be constructed. This base should be made out of a 2'' x 6'' (minimum) or 2" x 8" (recommended) on edge, to allow for the installation of a P-trap and the required 1/4"per foot gravity flow towards the pump unit.
The Sanishower is a small drain pump that may be used to pump waste water away from a shower, sink, bar sink, or other fixture. The Sanishower is small enough to fit underneath a raised shower base. Alternatively, it can be placed behind a wall or beside a shower. The Sanishower will pump wastewater up to 12 feet in height and/or 100 feet away from a soil stackus

YOU MIGHT ALSO LIKE