Ironcompany 6 Bar Gun Rack Olympic Bar Wall Rack - The Gun Rack Bar Storage Rack from Ironcompany is an American-made wall mounted racking system made from heavy duty steel for horizontal storage of up to six Olympic weight bars. The wall mounted barbell rack gets your bars off the floor and conveniently onto your wall to better organize your space and offer easier access to group exercise participants in your facility. The Olympic weight bar wall rack fits all styles of barbells including 20kg, 15kg, short bars, aluminum training bars, and even most axle bars. This barbell holder is built tough from 7 gauge steel that is laser cut for an attractive look and finished with a durable black powder coated finish for longevity. The Ironcompany ICGRBS 6 Bar Gun Rack can be installed to the wall in one of two ways to support your facility's needs. When mixing and matching shorter bars (such as 5' straight bars) with longer bars, the two vertical brackets can be set at 48" apart which allows the bar shaft to rest into the notch on each side. The laser cut notches on each side are uniquely designed with a large enough curvature which also permit them to perfectly cradle a two inch diameter bar sleeve. This allows for alternate placement of the brackets at 64" apart so that the gun crack notches can hold the bar sleeves rather than the bar shaft. The wider wall mounting configuration is recommended for most men's 20kg Olympic Competition Bars and women's 15kg Olympic Training Bars as to not dull or scratch the bars' sharp knurling and shaft finish (such as black oxide or stainless) from repeated racking on and off the laser cut steel supports over time. When mounting to drywall or smooth plaster wall surfaces, either the 48 or 64" mounting option works perfectly with traditional 16"" center-on-center construction spacing of wooden studs. Olympic bars as shown in stock photos are for demonstration purposes only and are NOT included.

• Set of (2) gun rack brackets hold six Olympic Bars horizontally. 24" high. 5" deep from wall.
• MADE IN USA. 7-gauge steel produced by laser cutting and CNC bending. Black powder coated finish.
• Bar catch notches are rounded with 2" diameter curvature to hold Olympic bar sleeves or shaft.
• 3 mounting holes per bracket spaced 10" apart. Recommended spacing 48" or 64" apart. 15 pounds total
• Intended for installation to wood studs or masonry. Mounting hardware and Olympic bars NOT included