Gizmo Dorks
We provide the highest quality 3D printing materials such as ABS, PLA, HIPS, PVA, and more. Our filaments are run with tight tolerances. There are no air bubbles or oily residues. Every filament comes loaded on a durable, hard plastic spool, not a cheap, flimsy cardboard spool.

Wood is a new FDM filament that was developed to print wooden-like objects. The filament contains recycled wood with PLA and some binding polymers. Printing at lower temperatures will produce a brighter color, and if you adjust the print temperatures to be higher it will create a darker print. Adjusting the print temperature by as little as 10 degrees will vary the coloration giving the printed object a "grainy" look. The printed wood will appear rough and similar to Medium Density Fiberboard, known as MDF. Wood filament is less viscous compared to PLA or ABS during printing. Please add a little extra extrusion to the beginning of the print to help prevent dry extrusion. Also, increasing the retraction setting during slicing will reduce "leakage." The wood filament will appear delicate after print, so please allow the wood filament to set approximately thirty to sixty minutes after printing.

Compatible with RepRap, Makerbot, UP!, Lulzbot, Afinia, Solidoodle, MakerGear, Printrbot LC, and more!

FAQ?

Is the spindle hole large enough to fit my Makerbot printer?
Yes! Our spindle holes are large enough to fit the Makerbot printers. You don't have to worry about fabricating a spindle extension any longer. *NOTE, these spools fit inside of the new Makerbot 5th generation printer drawers!

What are some printing tips?
Please use Kapton tape or 3M blue tape. Please use in well ventilated areas.

What are optimum print settings?

• Extrusion Temp: 220°C - 230°C
• Heated Bed Temp: 110°C - 120°C
• Layer Height: .2-.25 mm

• Made from PLA and recycled wood fibers
• Extrusion temperature adjustments will show changes in print color
• Prints just like normal PLA with wood texture and feel
• Extrusion temperature range: 190 - 230°C
• Diameter tolerance: +/- 0.05mm